Demo Lift: Difference between revisions
(Created page with "=Model lift system with CANopen components= The Heilbronn University is known for many years through congresses and conferences in the field of elevators. Now, a research projec...") |
No edit summary |
||
| Line 17: | Line 17: | ||
=Sponsors= | =Sponsors= | ||
Because some components of the elevator model are very expensive, especially the electronic components, | Because some components of the elevator model are very expensive, especially the electronic components,you are kindly invited to contribute with your products. We will attach your logo at a prominent place on the model to indicate you as a sponsor. | ||
The following companies already contribute to the model: | |||
SICK AG (light curtain model for fusing) | |||
... To be continued with your help .... | ... To be continued with your help .... | ||
If you are interested in becoming a sponsor, please contact Mr. Meroth at the following address: ansgar.meroth (at) hs-heilbronn.de | If you are interested in becoming a sponsor, please contact Mr. Meroth at the following address: ansgar.meroth (at) hs-heilbronn.de | ||
Revision as of 22:52, 1 September 2011
Model lift system with CANopen components
The Heilbronn University is known for many years through congresses and conferences in the field of elevators. Now, a research project is started, that aims at various aspects of the automation of elevators with CANopen, such as compliance testing "in the loop" and the possibilities of telemetry and remote diagnostics. Suggestions and discussions are currently on the project of Mr. Hellmich, Böhnke + Partner, Bergisch Gladbach.
You too could be part of this project!
In order to obtain a realistic test environment, a group of four students from the master's degree courses in Mechanical Engineering and Mechatronics at the Heilbronn University under the direction of Prof. Dr.-Ing. Ansgar Meroth started a project in which an elevator system in 1:10 scale model is built and networked via CANopen original components. All components are concurrently simulated by a corresponding function in Vector CANoe and MathWorks Matlab / Simulink models, allowing to replace components in real time by simulated functions.
The resulting model system shall demonstrate the CANopen standards and provide an opportunity to review new components for conformity. It differs fundamentally from a previous model, designed in the MG lift, by a higher mechanical detail. With its open architecture, a combination of both demonstrators is possible.
Model
The objective of the model is to construct and build an elevator system in 1:10 scale. The model will show two shafts, each with three floors and a cabin per shaft. The functionality will correspond as far as possible to the actual features of real elevators. However, due to the miniaturization and the better handling all control panels and control units are not directly attached to the model, but separated in a separate cabinet.
Since the use of this model to fairs and exhibitions is possible and desirable, as many components will be provided with windows or transparent to allow a better insight. Furthermore, the model will be secured, so that visitors can not touch moving parts or electrical components. To permit the use at exhibitions, the model will be transportable. This leads to additional demands on the model. The model with dimensions of 1200 mm x 600 mm x 400 mm (HxWxD) is transportable. Consequently, splitting of the model and securing the movable parts is guaranteed.
Sponsors
Because some components of the elevator model are very expensive, especially the electronic components,you are kindly invited to contribute with your products. We will attach your logo at a prominent place on the model to indicate you as a sponsor.
The following companies already contribute to the model: SICK AG (light curtain model for fusing)
... To be continued with your help ....
If you are interested in becoming a sponsor, please contact Mr. Meroth at the following address: ansgar.meroth (at) hs-heilbronn.de